How It Works
In the Ground in Minutes. Holding for Seasons.
No special skills, no extra tools, no second trip back to re-tighten. Here’s the entire install, start to finish.
Twist It In
Seat the Twister anchor in the 28″ Metal T-Bar and twist it into undisturbed soil just outside the root ball, angled slightly away from the trunk. The helical flights pull it down: no hammers, no rebar, no driving rods.
Loop & Lock
Run the olive drab U.V.-stabilized webbing around the trunk above the lowest sturdy branch, then back down through the anchor head. The wide, soft webbing won’t bite into bark.
Tension & Walk Away
Pull the webbing through the Hi-Vis yellow tensioner and snap it tight. Properly installed, it does NOT loosen, and the bright tensioner doubles as your visibility marker, so no warning tape is needed.
Take the Instructions to the Jobsite.
Printable install instructions, available in English and Spanish.
Installation Tutorials
Watch the Install.
Three real installations, start to finish. Filmed on site with the tools you already carry.
Drive Rod Install
The fastest method, using a cordless half-inch impact.
3-Anchor Rootball Kit
Full three-anchor rootball tie-down, step by step.
4-Anchor Rootball Kit
The four-anchor configuration for larger rootballs.
In the Field
Common Install Scenarios.
Standard Residential Planting
One to three anchors per tree depending on caliper. For most landscape trees up to 3″ caliper, three anchors spaced evenly at 120° gives a balanced hold.
High-Wind / Coastal Sites
Use three anchors and set them farther from the trunk for a wider stance. Sandy soils take the anchor easily: keep twisting until all flights are buried.
Compacted or Clay Soil
Start the tapered tip with firm downward pressure on the T-Bar. If you hit resistance mid-twist, back off a quarter turn and continue: never hammer the anchor.
Removal & Reuse
At the end of the staking period, twist the anchor back out with the T-Bar. Anchors, webbing, and tensioners can be inspected and redeployed on the next planting.
FAQ
Straight Answers.
Do I need any tools besides the kit?
No. The 28″ Metal T-Bar included in every starter kit is the only install tool required. There are no hammers, mallets, driving rods, or rebar involved.
Will the tensioner loosen over time?
No. The Hi-Vis yellow tensioner is designed so that it does NOT loosen when properly installed. It also eliminates the need for warning tape because of its high-visibility color.
Will the webbing damage the bark?
No. The olive drab webbing is a wide, soft U.V.-stabilized multi-filament polypropylene that distributes load across the trunk instead of cutting in like wire or rope.
How long should a tree stay staked?
Most landscape trees establish in one growing season. Inspect at 6–12 months; once the root system has taken hold, twist the anchors out and reuse them.
Where is Twister made?
Every component is manufactured and assembled in the United States of America, at our facility in Bradenton, FL.
Where can I buy it?
Twister is sold through our distributor network. Use the Find a Distributor page and we will route you to the closest seller.